America's Pride Group
STAY INFORMED
Home  |  Products  |  Contacts  |  Payment Options  |  Resources  |  Site Map
To place order, fax or mail us order form or lease application, or use our contact information.

Back to Omni Waste / Used Oil Burners

Typical Installation


Omni Typical Installation

  1. 8" Stack (check local codes)
  2. 4-1/2" all thread hangers. Heater must be mounted level.
  3. 115 VAC 20 amp power source. Wire and conduit per local codes.
  4. Low voltage thermostat wire to "T" terminals of oil primary control on burner.
  5. Oil suction line, 3/8" copper tubing.
  6. Oil feed line, 3/8" to bulkhead connector on heater cabinet.
  7. Suction line 6" minimum from bottom of supply tank to prevent sludge from being introduced into the supply line.

Back to Previous Page
  Home  |  Products  |  Contacts  |  Payment Options  |  Our Partners  |  Site Map
Powered by E-Volve